As we know, Shot blasting machines will appear lots of different problems during the process. Here we will show you some common problems and treatment methods of shot blasting machines.
Hope you can find the answer to solve the problems of Shot Blasting Machines.
First, The efficiency of dust collector is low.
1. The fan wire of dust collector being wrongly connected, so the fan inversed. It should be rewired.
2. The filter cartridge in the dust collector is not tightly installed or damaged, or the filter cartridge is missing.
3. The connection joint of dust removal pipeline is not sealed well. It should be ensured that each parts in good seal sealing.
4. The cleaning work piece did not filter sand as require. The molding sand left too much and the dust content in cleaning inlet is too high.
5. The anti dust blowing mechanism is not enabled or too less, which results in the dust blocked the cartridge. It is advisable to remove the dust attached on the filter cylinder timely.
Second, The dust gathering by dust collector containing too much shot.
The air on the splitter is too strong, it should be adjusted properly until it can guarantee the dust removing effect without sucking out the shots.
Third, Bucket elevator is not running.
1. Clamp and remove the oversize particles at the elevator bottom.
2. The belt slip. (Adjusting the tensioner and the tensioner belt of diving wheel.
3. The elevator pellets is too much at the bottom. The elevator should be stopped in turn first, then the pellets be cleared. 
Post time: Jan-07-2019