What are the effects of high temperature and high humidity on the double hook shot blasting machine?

In a high temperature and high humidity environment, when using a double hook shot blasting machine, the reducer, motor, blade, etc. are easy to generate heat, and the temperature of the air itself is high and the heat is high. The shot blasting machine is not easy to heat up. When working in this situation, the consumption of the accessories of the double hook shot blasting machine will increase exponentially. Since the double hook shot blasting machine itself is in a rainy, humid and humid environment, the electrical components of the shot blasting machine will age and short-circuit. This situation requires special attention. The steel grit used in the double hook shot blasting machine is easy to rust in a humid environment, and the rusty steel grit is easy to damage the lifting belt and the spiral of the shot blasting machine during use.

Therefore, in the environment of high temperature and humidity, the double hook shot blasting machine should be repaired, the parts that need to be replaced should be replaced in time, and the oil should be filled in time. In addition, high-quality materials should be used when selecting materials for the parts of the double hook shot blasting machine.

For example, the protective device of the double hook shot blasting machine, the blades, etc. should be made of high chromium, the grease should be of high quality, and bearings should be used. At the same time, the production workshop of the double hook shot blasting machine should be well ventilated and cooled. Only in this way can the service life of the shot blasting machine be more effectively extended. Generally speaking, the wear-resistant parts and wearing parts of the double hook shot blasting machine are made of high-chromium wear-resistant cast iron. In terms of service life, the service life of the blade exceeds 500 hours, while the side plate and top plate need at least 800 hours. The end plate should reach 1200h, the directional sleeve separation wheel should reach 1800h, the main body cover should be no problem within one year, and the shot blasting machine that has been used for more than 2 years is still in good condition. However, some shot blasting machines suffered severe wear after three to four months of operation.